Zendrum Forums

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: Calibration does not set max output properly on knobs  (Read 1864 times)


  • Tribal Scout
  • **
  • Offline Offline
  • Posts: 52
    • View Profile
Calibration does not set max output properly on knobs
« on: April 17, 2014, 10:00:53 PM »

Hey all.
Discovered something weird tonight... my knobs do not go all the way up to 127 after calibrating everything.
They range from 0-124, and appear to be on the same response curve as the "3" setting (e.g. the beginning of the turn rockets up the value and then it slows down to where the increases only come a couple per centimeter of rotation)

I found that, if I use ZenEdit and drop the "max" output of the knobs to about 96 (they started ~98.5 after calibration) then they will read all the way up to 127.

So, 1) I'm confused why calibration of the knobs doesn't allow reaching the value of 127 by default, and
2) I'm confused why setting the "max" output of these knobs to 96 results in a value of 127 being reached. You would think that setting the max to 127 would result in 127.
Pages: [1]   Go Up