Yes, Iam using the full version as the two areas are gray, but I cannot transmit sysex.
1. I close Zenedit 2 then open MIDI-OX and vice versa before I use either one as I found out early on one blocks the other from proper use.
2. I tried several transmits, no luck.
I see this difference between the two, sequnce as follows:
a. within zenedit, I go to the sysex transmit window, and on the zendrum to the Er, push the up arrow button on the back; the Er starts blinking... I then hit the transmit on zenedit and the "note-on light" blinks once, the Er continues to blink and when the transmit in zenedit says it is done, nothing else on the zendrum changes until I press the right arrow button, then the Er stops blinking. I go to the Save function and when applying the Save it just flips righ to the Pr display; no change takes place in the zendrum.
b. When I use MIDI-OX and transmit the sysex, my numeral display on the zendrum continues to blink, as does the note-on display light. When the transmit is done, the Er and note-on light stops blinking, and then the mode change light starts blinking. When I then go to Save on the zendrum and it questions the save, I hit the up arrow on the zendrum, the 'SA' displays in the window, and then it goes to the Pr display, and the change is saved and operable.
So there is no recognition of the sysex dump from zenedit to the zendrum within the program itself. Once before we had this issue ISTR, and it had something to do with the zendrum seeing the beginning of the transmission but not recognizing when the transmission ended. Could this be the same problem again?